Operating instructions

Page 107 Power Equipment Usage Manual (Rev. 5/10)
21.2.5. Routing the Workpiece
Normally, you feed a router opposite to rotation direction. This gives you just
enough resistance to maintain control and avoid kickback.
When feeding a workpiece into the spinning bit of the router, you want to choose the direction that
forces the bit to push the wood back against you. This direction changes depending on whether the bit
is above or below the workpiece.
a. Bit BELOW workpiece:
• If the BIT is setup to cut BELOW the workpiece, feed from LEFT to RIGHT.
• Stock to be routed should move over the top of the bit using push pads to securely hold
workpiece and protect your fingers.
b. Bit ABOVE workpiece:
• If the BIT is setup to cut ABOVE the workpiece, feed from RIGHT to LEFT.
• Be extra careful not to run your fingers under the spinning bit – keep a safe distance
between your fingers and the bit.