Operating instructions

Page 47 Power Equipment Usage Manual (Rev. 5/10)
• Loosen Bevel Latch Lock Handle.
• Unlock a Bevel Latch Lever (one on each side).
• Move saw left or right to desired angle of cut.
• Lock Bevel Latch Lever.
c. Basics of making a cut:
• Line up the cut mark with the blade.
• Depress trigger switch to turn ON:
o Allow blade to reach full RPM before making cut.
o Hold stock firmly against table and fence.
o Do not force blade down – Lower saw head smoothly and slowly.
• Release the trigger switch to turn OFF.
o Allow the blade to stop before raising saw head.
d. Crosscuts (Cutting stock across grain at any angle):
• Stock smaller than 2x8” – Tighten Rail Lock Knob to prevent saw from sliding forward on
rails.
• Stock larger than 2x8” (or 2x6” if at 45 degree miter):
o Loosen Rail Lock Knob.
o Pull saw out toward you.
o Lower saw head down toward workpiece.
o Slowly push saw back to complete cut.