Operating instructions

Page vi Power Equipment Usage Manual (Rev. 5/10)
16.5.1. Tailstock Movement .......................................................................................................................... 79
16.5.2. On/Off Switch .................................................................................................................................... 79
16.5.3. Spur Center ........................................................................................................................................ 79
16.5.4. Face Plate .......................................................................................................................................... 80
16.5.5. Drift Rod ............................................................................................................................................ 80
16.5.6. Tool Rest ............................................................................................................................................ 80
16.5.7. Changing Spindle Speeds ................................................................................................................... 81
16.5.8. Removing & Installing Live Center ..................................................................................................... 81
16.6. SETUP & USE – 20” POWERMATIC LATHE ........................................................................................................... 81
16.6.1. Key, On/Off, Reverse, Speed Control ................................................................................................. 81
16.6.2. Headstock & Tailstock Movement ..................................................................................................... 82
16.6.3. Tool Support ...................................................................................................................................... 82
16.6.4. Locking Handles ................................................................................................................................. 83
16.6.5. Live Center & Cone ............................................................................................................................ 83
16.6.6. Indexer ............................................................................................................................................... 83
16.6.7. Centers – Installing and Removing .................................................................................................... 84
16.6.8. Face Plate – Installing and Removing ................................................................................................ 84
16.6.9. Comparator – Installing and Using .................................................................................................... 85
16.6.10. Speed Change .................................................................................................................................... 86
17. MORTISER, HOLLOW CHISEL (POWERMATIC 719A) ................................................................................. 87
17.1. SAFETY PRECAUTIONS ...................................................................................................................................... 87
17.2. SET UP & USE – HOLLOW CHISEL MORTISER ....................................................................................................... 88
17.2.1. Installing a Chisel & Bit ...................................................................................................................... 88
17.2.2. Work Stop .......................................................................................................................................... 89
17.2.3. Through Mortise Cuts ........................................................................................................................ 89
17.2.4. Operation........................................................................................................................................... 89
18. NAILER, BRAD – PNEUMATIC (PORTER-CABLE BN200A) .......................................................................... 91
18.1. SAFETY PRECAUTIONS ...................................................................................................................................... 91
18.2. SETUP & USE – PNEUMATIC AIR/OIL .................................................................................................................. 92
18.3. SETUP & USE – BRAD NAILER ............................................................................................................................ 92
18.3.1. Preparing the Tool ............................................................................................................................. 92
18.3.2. Using the Tool .................................................................................................................................... 93
18.3.3. Clearing a Jammed Fastener ............................................................................................................. 93
19. ROUTER, PLUNGE (PORTER-CABLE 6931, PORTER-CABLE 1001) ............................................................... 94
19.1. SAFETY PRECAUTIONS ...................................................................................................................................... 94
19.2. SETUP & USE – PLUNGE ROUTER ....................................................................................................................... 95
19.2.1. Selecting the Bit ................................................................................................................................. 95
19.2.2. Installing & Removing the Bit ............................................................................................................ 95
19.2.3. Assembling the Motor in the Router Base ......................................................................................... 96
19.2.4. Adjusting Depth of Cut ...................................................................................................................... 96
19.2.5. Adjusting Sub-base Alignment ........................................................................................................... 97
19.2.6. Installing Motor in Plunge Base ......................................................................................................... 97
19.2.7. Removing Motor from Plunge Base ................................................................................................... 97