Operating instructions

Page 88 Power Equipment Usage Manual (Rev. 5/10)
17.2. Set Up & Use – Hollow Chisel Mortiser
17.2.1. Installing a Chisel & Bit
a. Loosen lock screw, shown in Figure 1.
b. Insert chisel bushing (with the hole facing forward) into
the head. Tighten the screw just enough to hold the chisel
in place.
NOTE: Set the slot in the side of the chisel to the left or
right, NOT to the front or back. This will allow chips to
escape when cutting mortises.
c. Push the chisel up as far as possible into the head. Then
lower the chisel approximately 1/16" to 3/16", depending
on the type of wood being worked. Tighten the screw to
hold chisel in place.
Figure 1