Use and Care Manual

13 – English
ASSEMBLY
INSTALLING THE MITER LOCK KNOB
See Figure 7.
To install the miter lock knob, place the threaded stud on
the end of the miter lock knob into the threaded hole in the
control arm. Turn clockwise to tighten.
LOCKING / UNLOCKING THE SAW ARM
See Figure 7.
To unlock and raise the saw arm:
 Firmly grasp the “D” handle and apply downward pressure
while at the same time pulling the lock pin out and away
from the saw housing.
 Release the lock pin and slowly raise the saw arm.
To lock the saw arm:
 Firmly grasp the “D” handle and apply downward pressure
while at the same time pushing the lock pin in and toward
the saw housing.
 Release the lock pin allowing it to lock the saw into place.
INSTALLING THE REAR BRACKET
See Figure 8.
WARNING:
A rear bracket is included with this miter saw to prevent
tipping if the saw arm is released suddenly. Do not use
this saw before installing the rear bracket and securely
mounting the saw to a work surface or stand.
Remove the screws from the Rear Bracket and set aside.
Slide the bracket in the openings on the saw base,
aligning the holes underneath the base with the holes in
the bracket.
Insert the screws into the holes and tighten securely.
INSTALLING THE BEVEL LOCK KNOB
See Figure 8.
To install the bevel lock knob, slide the washer onto the
threaded stud on the end of the bevel lock knob then place
the knob into the threaded hole on the back of the saw. Turn
clockwise to tighten.
BLADE WRENCH
See Figure 8.
A blade wrench is included with this saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws. A
storage area for the blade wrench is located on the back of
the left miter fence.
Fig. 7
Fig. 8
REAR BRACKET
SCREW
BLADE
WRENCH
STORAGE
“D”
HANDLE
LOCK PIN
Fig 9
DUST BAG
EXHAUST
PORT
MITER LOCK KNOB
CONTROL ARM
DUST BAG
See Figure 9.
A dust bag is provided for use on this miter saw. It fits over the
exhaust port on the upper blade guard. To install, squeeze the
two metal clips to open the mouth of the bag and slide it on the
exhaust port. Release the clips. The metal ring in the bag should
lock in between the grooves on the exhaust port. To remove the
dust bag for emptying, simply reverse the above procedure.
BEVEL LOCK KNOB
WASHER