Use and Care Manual

16 – English
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
ASSEMBLY
Fig. 14
SQUARING THE BLADE TO THE FENCE
See Figures 14 - 19.
 Remove the battery pack from the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock knob approximately one-half turn
and press the detent release button.
 Rotate the miter table until the pointer aligns with zero
dentent on the miter scale.
 Release the detent release button, engaging the positive
stop notch, then tighten the miter lock knob to secure the
miter table.
 Loosen bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 14.
 If the front or back edge of the saw blade angles away
from the square as shown in figures 15 - 16, adjustments
are needed.
 Loosen the fence screw and slide the partial sliding miter
fence toward the blade to access the socket head screws
securing the left miter fence to the table.
 Using the blade wrench, loosen the socket head screws
that secure the miter fence to the miter table.
MITER
TABLE
MITER
FENCE
BLADE
FRAMING
SQUARE
VIEW OF BLADE SQUARE WITH FENCE
 Rotate the miter fence left or right until the saw blade is
parallel with the square.
 Retighten the screws securely and recheck the blade-to-
fence alignment.
 Return the partial sliding miter fence to the home position
and retighten the fence screw to secure.
VIEW OF BLADE NOT SQUARE WITH FENCE,
ADJUSTMENTS ARE REQUIRED
Fig. 15
Fig. 16
MITER
FENCE
MITER
FENCE
MITER
TABLE
MITER
TABLE
BLADE
BLADE
FRAMING
SQUARE
FRAMING
SQUARE