Use and Care Manual

17 – English
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
ASSEMBLY
The saw has two scale indicators, one on the bevel scale and
one on the miter scale. After squaring adjustments have been
made, it may be necessary to loosen the indicator screws
and reset them to zero. See figures 18 - 19.
SQUARING THE BLADE TO THE MITER TABLE
See Figures 20-22.
 Remove the battery pack from the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock knob to unlock the miter table.
 Rotate the miter table until the pointer aligns with zero
detent on the miter scale.
 Tighten the miter lock knob to lock the miter table.
MITER FENCE
SOCKET HEAD
SCREW(S)
SOCKET HEAD
SCREW(S)
SCALE
INDICATOR
INDICATOR
SCREWS
BEVEL
SCALE
Fig. 17
Fig. 18
Fig. 20
 Loosen bevel lock knob and set saw arm at 0
°
bevel (blade
set 90
°
to miter table). Tighten bevel lock knob at stop.
 Place a square against the miter table and the flat part
of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 20.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 21 and 22, adjustments
are needed.
 Loosen the bevel lock knob.
COMBINATION
SQUARE
BEVEL
LOCK
KNOB
MITER
FENCE
PARTIAL
SLIDING
MITER
FENCE
FENCE
SCREW
INDICATOR
SCREW
MITER
SCALE
SCALE
INDICATOR
Fig. 19
MITER
TABLE
BLADE