Use and Care Manual

18 – English
ASSEMBLY
 Adjust positive stop adjustment screw to bring saw
blade into alignment with the square. See Positive Stop
Adjustment in the Adjustments section.
 Retighten bevel lock knob. Recheck blade-to-table
alignment.
MITER
TABLE
BEVEL
LOCK
KNOB
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
Fig. 22
Fig. 21
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0
°
and 45
°
angles.
The saw has two scale indicators, one on the bevel scale and
one on the miter scale. After squaring adjustments have been
made, it may be necessary to loosen the indicator screws
and reset them to zero. See figures 18 - 19.
OPERATION
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
This product has been designed only for the purposes listed
below:
 Cross cutting wood and plastic (do not cut metals,
ceramics, or masonry products)
 Cross cutting miters, joints, etc. for picture frames
moldings, door casings, and fine joinery
 Bevel cutting and compound cutting of lumber and
moldings
BEVEL
LOCK
KNOB
MITER
FENCE
MITER
TABLE
COMBINATION
SQUARE
COMBINATION
SQUARE
BLADE
BLADE