Use and Care Manual

7 – English
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Keep water discharge pointed away from all electrical
devices to reduce the risk of electrocution or electric
shock.
WARNING:
Ensure all hose connections are secure before using the
transfer pump Spilled water and leaks can result in a
slippery surface and create a slip and fall hazard.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Always remove battery pack or unplug power cord from
your product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack or unplugging power cord will prevent
accidental starting that could cause serious personal
injury.
APPLICATIONS
You may use this tool for the purpose listed below:
Drain or remove water from flooded areas, clogged sinks,
water basins, etc.
NOTICE:
This product is designed to be powered by either a
RYOBI
™
One+
™
18V battery pack (DC mode) or by electric
power (AC mode). Either power source can be used by
installing an approved battery pack or power cord into
the product as described in this manual.
INSTALLING/REMOVING BATTERY PACK
See Figures 4 and 6, page 11.
 Set the ON/OFF switch to the OFF position.
 Press outward on the tab to open the battery cover latch.
 Insert the battery pack into the battery port.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Close the battery cover and press until it snaps shut.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
INSTALLING/REMOVING POWER CORD
See Figures 5 and 6, page 11.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
 Press outward on the tab to open the battery cover latch.
 Insert the female end of the power supply cord into the
product as shown until it clicks into place.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
 To remove the power cord, unplug the cord from the
power source.
 Press the release button on the top of the female end of
the power supply cord and remove from the tool.
STARTING/STOPPING THE TRANSFER PUMP
See Figure 6, page 11.
 Add two drops of oil into the water inlet before and after
each use.
 Add water to the water inlet side of the pump to prime
the impeller.
Connect the product to an AC or DC power supply.
WARNING:
Hybrid tools are always in operating condition. Therefore,
unit should always be in the OFF position, with the battery
pack removed and power cord disconnected, when not in
use. Do not leave pump on while unattended. Failure to
follow these instructions could result in serious personal
injury.