Owner's Manual

990000202
5-28-13 (REV:04)
Cold Engine:
Warm Engine:
To Stop:
DEPRESS the “STOP” switch to the STOP position
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
PRIME press the PRIMER BULB 10 times slowly.
SET CHOKE lever to " FULL CHOKE " position.
Do not squeeze throttle trigger.
With throttle at idle,
PULL starter grip
sharply until engine runs. (Max 3 times)
 If 60°F or lower, continue to pull starter grip until
engine runs.
 If above 60°F, set choke lever to “HALF CHOKE” and
pull starter grip until engine runs.
1 GALLON
GAS
After 10 seconds, SET choke lever to RUN position.
10x
10x
RUN
RUN
4
1
2
3
5
6
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
Later uses: Check engine lubricant level and add lubricant if needed.
For any questions about operating or maintaining your product, call the Ryobi
®
Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ryobitools.com
Press the PRIMER BULB 10 times slowly.
Set choke lever to RUN.
Pull starter grip until the engine runs.
NOTICE
Do not use E15 or E85 fuel (or fuel
containing greater than 10% ethanol) in
this product. It is a violation of federal
law and will damage the unit and void
your warranty.
5
2
4
6
8
7
FULL
CHOKE
RUN
HALF
CHOKE
3
1
HALF
CHOKE