Instructions / Assembly

998000882
12-29-21 (REV:02)
FIRST TIME ASSEMBLY STARTING THE UNIT
Install at least two 40V batteries on either the left side (PAIR A) or the right side (PAIR B) (see page 9).
1
2
Press and hold the start button. Pull the bail toward the handle and release the start button when the
motor and tines starts (see page 9).
3
Insert the start key with the arrow facing a pair of charged battery packs (see page 9).
Connect wire assembly (see page 7).
Attach ballast tank (see page 7).
Attach dirt flap (see page 8). Adjust side panels (see page 8).
Install depth bar handle (see page 8).
Install the wheels. Align the hole in the wheel
with the hole farthest from the end of the axle
(see page 7).
Install the side panels (see page 8).
Install the tines (see page 8).
2
4
6 9
11
5 8
7
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual
before using this product. All page references refer to the operator’s manual.
RY40702 QUICK REFERENCE GUIDE
Install the handle (see page 7).
Install the bull bar using the
hex key provided (see page 7).
1
3
 
 




Make the most of your purchase! Go to www.ryobitools.com and register your new tool online.
For questions about operating or maintaining your product please call, 1-800-525-2579.
Install the depth bar (see page 8).
10