OPERATOR’S MANUAL 14.4 VOLT WORKLIGHT FL1400 BATTERIES AND CHARGERS SOLD SEPARATELY Your worklight has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Thank you for your purchase.
TABLE OF CONTENTS Introduction ..................................................................................................................................................................... 2 Warranty .......................................................................................................................................................................... 2 General Safety Rules ........................................................................................................
GENERAL SAFETY RULES If wrapped or in contact with fabrics, the worklight lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the worklight lens to come in contact with anything. WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Use only recommended battery pack and charger.
SAFETY RULES FOR CHARGER Do not let gasoline, oils, petroleum-based products, etc. come in contact with plastic parts. They contain chemicals that can damage, weaken, or destroy plastic. WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock.
SYMBOLS Some of the following symbols may be used on this worklight. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the worklight better and safer.
OPERATION WARNING: The safe use of this product requires an understanding of the information on the tool and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. BATTERIES AND CHARGERS SOLD SEPARATELY 180° ROTATING HEAD CHARGER SWITCH TRIGGER BATTERY PACK RED LED YELLOW LED GREEN LED Fig. 3 Fig. 1 BULB REPLACEMENT Always ask for replacement bulb number 981128003.
OPERATION Normally the red LED on charger will come on. This indicates the charger is in fast charging mode. Red LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode. NOTE: The green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply.
MAINTENANCE BATTERIES BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING The battery pack for this worklight is equipped with nickelcadmium rechargeable batteries. Length of service from each charging will depend on the type of work you are doing. The batteries in this worklight have been designed to provide maximum trouble-free life. However, like all batteries, they will eventually wear out. Do not disassemble battery pack and attempt to replace the batteries.