Installation Guide

For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time

INSTALLATION INSTRUCTIONS

WAVE

VANITY

V-WAVE-24DK

SUGGESTED TOOLS AND MATERIALS

Philips Screwdriver Level Drill Tape Measure Safety Glasses

1 0 '

ROUGHING IN

24" [610.0mm]

34" [864mm]

16" [406.1mm]

30" [762mm]

21-1/2" [546.0mm]

4” [101.6mm]

3" [76.0mm]

8" [204.0mm]

THANK YOU FOR CHOOSING XYLEM

Please take a few minutes to review this manual before you start installation. If you encounter any

installation problems, please don’t hesitate to contact us. Before you begin, please observe all local

building codes. Unpack the new product and inspect for damage. The appearance of your vanity may

differ from the illustrations in this guide. This instructions still apply. Please ensure the finished wall is

straight and plumb and the floor is flat and perpendicular to the finished wall.

PAGE 1
INSTALLATION INSTRUCTIONS TM WAVE TM VANITY V-WAVE-24DK THANK YOU FOR CHOOSING XYLEM Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage. The appearance of your vanity may differ from the illustrations in this guide. This instructions still apply.
PAGE 2
INSTALLATION INSTRUCTIONS • • • • • Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level. Mark the supply and drain locations on the inside of the vanity back wall. Move the vanity away from the wall and cut the marked supply and drain locations from inside. Position the vanity against the wall, aligning the supply and drain locations with the cut holes. Install the countertop, sink, drain and faucet according to the manufacturer’s instructions.