User's Manual

WTS

8875 801-267

Operation

5 Operation

5.1 Start up

1. Push the power button on the WCU and hold for 2 seconds. A

green LED will indicate that the WCU is turned on.

Note!

If the system is in Tampering Kill mode after power up, select

the command RESET on the CGUN. Aim at a WDU and fire

the CGUN to reset the system.

5.1.1 First time procedure

The very first time the system is used, you may want to make sure the

WDUs are properly associated to the WCU.

1 Select the command TEST on the CGUN and fire at the WDU.

2 The system will generate the audio message ASSOCIATED + ID

NUMBER.

5.2 Target engagement

5.2.1 Ballistic (BT46) simulation

The hit area is 3 x 3 meters. The defined origin is in the center of the

WDU.

A hit is detected when the point of impact is within the hit area, the

effect will be Kill or Hit No Effect.

If a hit is detected outside the hit area the effect will be Near miss.

5.2.2 MILES/One-way simulation

When one-way simulation is used, no hit coordinates are presented.

The soldier will only see the effect on the target - Kill, Hit No Effect or

Near miss.