User's Manual

R60 Station
R60 User Manual
Document Number
Version
Date
7000 120-019
A1
2022-08-10
Page 13 (98)
2 FRONT PANEL
2.1 Power Button
The R60 power button is a momentary push button with a built in RGB LED for status
indication.
The R60 supervisor will always be powered on and accessible while either AC or DC
power is available.
2.1.1 Operation
To power on the R60, push the button. The R60 station will power on immediately.
To power off the R60, push and hold the button depressed for at least 2 seconds.
2.1.2 LED Indications
LED Colour
LED Behaviour
Description
Black
Steady
Powered off and no AC or DC power is available
Black - Blue
Fade
AC or DC power source is available.
Powered off but supervisor is powered on.
Green - Blue
Fade
Powered on and is booting.
Green
Steady
Operational with no active alarms.
Red
Steady
Operational with at least one active alarm.
Green - Yellow
Fade
Operational with no active alarms.
Configured for hot standby and is currently operating in
standby mode.
Red - Blue
Fade
Software load in progress. The R60 is not operational.
Black - Red
Fade
Failure, the R60 is not operational
2.2 Front Display
2.2.1 Introduction
The R60 front display shows status information and other operational related
information. It is also possible to configure network communication settings.