Manualshelf

User's Manual

ManualsBrandsSAAB ManualsComputers & AccessoriesAids to Navigation Station
11121314151617181920
R60 Station
R60 User Manual
Version
Date
A1
2022-08-10
Page 20 (98)
3 GETTING STARTED
This section contains an introduction to the different variants of the R60. It also
describes how to connect to a R60 station and navigate the web GUI.
Section 3.10 suggests a step-by-step procedure to set up a new R60 Station.
3.1 R60 station variants and licenses
The R60 Station provides many different functions, not all of them are available in
every R60 station.
The R60 Station can be ordered in four different variants.
Receiving only
Aids-to-Navigation only (IEC 62320-2)
Standard Base Station (IEC 62320-1)
Full Base Station (IEC62320-1, IEC 62320-2, and IEC 62320-3)
The available functionality is determined by a license key. This license key is loaded on
the R60 at delivery and enables the functions ordered by the customer. The loaded
license key determines the variant and functionality of the R60 Station.
Common for all the variants is that they use the same hardware platform, and by
replacing the license key it is possible to change from one unit variant to another if
national regulations allow for it. It may be possible for the user to purchase a different
license key separately and upgrade the R60 to a different variant.
The variants as listed above are identified by different product name and part number.
The product label applied on the R60 station at delivery reflects the variant at delivery.
When a license update is performed, this will affect the product P/N.
For the user of this manual it is important to be aware that the web interface will
respond slightly differently depending on the variant of the R60. All R60 features are
always present in the web GUI, while features that are not licensed to operate in a
particular R60 variant are greyed out.
For more information on licensing, see section 4.
3.2 Installation and compatibility
The R60 Station can be supplied by AC or DC power, either as stand-alone or
connected to both AC and DC simultaneously. In case the R60 Station is connected to
both AC and DC at the same time, it uses AC and power and switches automatically to
using DC as backup in case of failure of the AC supply. For specifications on power
supply see Ref. 1
The web page GUI does not require any installation. The following standard web
browsers are recommended: