Manualshelf

User's Manual

ManualsBrandsSAAB ManualsComputers & AccessoriesAids to Navigation Station
21222324252627282930
R60 Station
R60 User Manual
Version
Date
A1
2022-08-10
Page 21 (98)
Internet Explorer (version 11)
Google Chrome (version 81)
Mozilla Firefox (version 75)
Microsoft Edge (version 41)
3.3 Connecting to the R60 web interface
To connect to the R60 for monitoring and configuration functionality follow these
instructions.
A standard web browser is used to access the R60 web GUI. Examples of compatible
web browsers are listed in section 3.2.
To connect to the R60 you must know the IP address of the R60 unit. Default IP
parameters are found in Ref [1].
A password is not required to connect to the R60 unit web page GUI. However, some
features in the GUI do require a password to be accessed.
Follow these few steps to connect to a R60 Station using the web page GUI:
1. Make sure the R60 Station is turned on.
2. Make sure the R60 Station is connected to a TCP/IP network and reachable from
the computer where the web GUI shall be accessed.
3. Open your web browser.
4. In the browser address field, type in the unit (ETH1 or ETH2) IP address in the
format xxx.xxx.xxx.xxx and press Enter.
If your browser can access the R60 unit, and if you have used the correct IP address,
the web GUI start page will now appear. The start page displays the four main
categories as shown in Figure 3-5.
3.4 Connecting to the R60 supervisor
To connect to the R60 for equipment supervision and configuration functionality
follow these instructions.
A standard web browser is used to access the R60 supervisor web GUI. Examples of
compatible web browsers are listed in section 3.2.
To connect to the R60 supervisor you must know the IP address of the R60 supervisor
unit and be connected using Ethernet port 3. Default IP parameters are found in Ref
[1]. It is not the same as the main web GUI.
A password is not required to connect to the R60 supervisor unit web page GUI.
However, some features do require a password.
Follow these few steps to connect to a R60 supervisor using the web page GUI:
1. Make sure the base station has power.