User's Manual

R60 Station
R60 User Manual
Document Number
Version
Date
7000 120-019
A1
2022-08-10
Page 28 (98)
3.10 Quick introduction to set-up of a new R60 station
This section describes the general procedure to set up a new R60 Station using the web
GUI. Only the basic procedure is described here, while section 5.5 contains a complete list
of all configurable settings and deals with more advanced topics.
Before starting: If current R60 settings are unknown, unplug the VHF antenna to avoid
unintended transmissions. Transmitting without an antenna does not damage the R60.
3.10.1 General set-up procedure
Follow the steps below in order to set up the base station parameters:
1. Install the R60 Station according to the installation manual (Ref [1]).
Make sure the R60 is connected to a TCP/IP network and reachable from the
computer where the web browser is used.
2. Turn on the power to the base station. See the installation manual for
instructions (Ref [1])
Also open an Internet browser tool (see section 3.2 for compatibility).
3. Connect to the R60 Station as described in section 3.3.
4. Select the main category Configure (see sections 3.5 and 3.9.3)
5. Type in the password and press Enter key or click on “Go”.
The default password is “Config” and it is case sensitive.
A new page with a number of sub-categories appear, like in Figure 3-7 (note:
the view can appear differently depending on the web browser size).