User's Manual

R60 Station
R60 User Manual
Document Number
Version
Date
7000 120-019
A1
2022-08-10
Page 36 (98)
15. If you changed any parameter on the Network settings page now is the time to
save the changes to the R60 station by clicking on the Save Changes button
that appears in the upper right corner of the page. If the IP address is changed,
the web browser will automatically be redirected to the new address.
16. If the R60 is to be used stand-alone, i.e. in a configuration without redundancy,
the basic setup is now complete. Otherwise, continue with the redundancy
settings described in section 3.10.2.
17. The setup is complete. If the VHF antenna was unplugged in the beginning of
the setup procedure, it can now be reconnected.
3.10.2 Set-up procedure for a redundant configuration
The R60 station can be installed as a part of a redundant solution (hot-standby).
Note, a hot-standby installation will require a hot-standby cable (P/N 7000 100-775,
see Ref [1] for further details).
Redundancy settings are found by using the navigator line and clicking on the
Configure main category and then select the Hot Standby sub category.
A page similar to Figure 3-14 appears.
Figure 3-14: Hot Standby category page. The settings in the picture specifies the R60 operation when
used in a configuration without redundancy