User's Manual

R60 Station
R60 User Manual
Document Number
Version
Date
7000 120-019
A1
2022-08-10
Page 87 (98)
Group
Parameter
Description
Self-Surveyed
Position
Shows the current self-surveyed position and its accuracy.
VHF Data Link
Status
Provides information about the current status of the VHF data link such as
the number of AIS/ASM units received recently (own base included), link
load (number of transmitted and received message last minute).
Hot Standby
Mode
Can be HS not active, forced or autonomous.
Status
Can be Master (i.e. the R60 is used for transmission) or Standby.
Alarm
Indicates if there are any hot standby alarms present.
SW/HW
Versions
Software
Version
Software version of R60 Station.
Hardware
Version
Hardware version of R60.
Supervisor
Software
Version
Software version of R60 supervisor.
Ethernet
Status of all Ethernet ports on the R60.
Local Storage
Shows the status, size and usage of the R60 local storage memory.
A R60 will only store data locally when storage is enabled and no network
system capable of handling stored data is connected to it.
Unit
Identification
Product number, license, hardware number and serial number of the R60
base station
Password
Password entry for configuration and maintenance functions.
Network
Configuration
IP Address
IP address of the R60 VDES Base station. (ETH3 is supervisor)
Netmask
R60 Netmask setting for the IP network connection.
Default
Gateway
R60 default gateway setting for the IP network connection.
Maintenance
Reboot
AIS/ASM
Hard reboot by cutting power.
Power
On/Off
Power on/shut down base station. Supervisor is always powered on when
main power is available.
Restore
Factory
Default SW
Initiates a restore of factory loaded software. Software restore takes
approximately 2 minutes.
Table 8-1 Parameter information provided via Supervisor GUI