Use and Care Guide

INSTALLATION
Removing bracket from skid Removing bracket from cabinet
Tools required: Phillips screw driver.
• Use a phillips screw driver to remove the four (4) screws from the L-bracket connecting
the unit to the wood skid (see image 1). Then remove the L-bracket from the unit (see
image 2).
Image 1
Image 2
• Remove skid by unscrewing all base rail anchor brackets. Place skid to the side.
• Carefully upright cabinet.
When lifting unit do not use the countertop as a lifting point.
Also remember to leave cabinet upright for 24-hours before plugging into power source.
• Set unit in its final location. Make sure there is adequate ventilation in this location.
Under extreme heat conditions (+100°F / +38°C) an exhaust fan may be necessary.
• Proper leveling of the unit is critical to operating success (for non-mobile models).
Effective condensate removal and door operation will be affected by leveling.
• The cooler should be leveled front to back and side to side with a level.
Warning: Installation without proper ventilation will void the manufacturer’s warranty.