Use and Care Guide

ELECTRICAL
Do not under any circumstances cut or remove the grounding prong from the power
• The power cord of this cooler is equipped with a grounding plug which mates with a
service representative.
• If the outlet is a standard 2-prong outlet, it must be replaced with the properly
grounded wall outlet.
• Have the wall outlet and circuit checked by a qualified electrician to make sure the
outlet is properly grounded. Check the incoming voltage with a voltmeter. If the
• DO NOT USE EXTENSION CORDS. The use of extension cords to connect the
• The cooler should always be plugged into its own dedicated circuit with a voltage
rating that matches the rating plate. This provides the best performance and also
It is strongly recommended that any servicing be performed by an authorized
standard grounding wall outlet to minimize the possibility of electric shock hazard.
cord. For safety this appliance must be properly grounded at all times.
NEVER USE AN ADAPTER PLUG!
prevents overloading wiring circuits which could become a fire hazard from over-
heated wires.
cooler will void the Metalfrio warranty. The unit must be close enough to the
• Never unplug your cooler by pulling on the power cord. Always grip the plug firmly
and pull straight out from the outlet.
• Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a power cord that has cracks or abrasion damage along its
length or at either of its ends.
• When removing the cooler away from the wall be careful not to run over or damage
the power cord.
results are anything less than 100% of the rated voltage for operation is noted,
it must be corrected immediately.
WARNING: Compressor warranties are voided if compressor burns out due to
low voltage.
NOTE: Wiring diagram can be referenced by removing the front louvered grill,
and looking on the inside cabinet wall.
electrical supply so that extension cords are never used.