Operating instructions

13
Sabine SWM4000 Smart Spectrum
®
Wireless
LIT-SWM4000-OG-EN-100205.indd
© 2010 Sabine, Inc.
SW40-H Handheld Transmitter
RF Transmitter Output
30 mW maximum (dependent on applicable
country regulations)
Dimensions (including EM-l1S cartridge)
270 mm x 52 mm dia.
Weight
250 g without batteries
Housing
Molded ABS handle and battery cup
Power Requirements
2 “AA” size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
SW40-T Beltpack Transmitter
Gain Adjustment Range
30 dB
Input Impedance
500 K
RF Transmitter Output
30 mW maximum (dependent on applicable country
regulations)
Dimensions
85 mm H x 70 mm W x 20 min D
Weight
97 g without batteries
Housing
Molded ABS case
Power Requirements
2”AA’ size alkaline or rechargeable batteries
Battery Life
>8 hours (alkaline)
SW40 Receiver
Operating Range Under Typical Conditions
100m (300 ft)
Note: actual range depends on RF signal absorption,
reection, and interference
Audio Frequency Response (+/- 2 dB)
Maximum: 20 kHz
Minimum: 50 Hz
(Overall system frequency depends on microphone element.)
Total Harmonic Distortion (ref. +/- 30 kHz deviation, 400Hz tone)
0.5%, typical
Dynamic Range
>100 dB A-weighted
Operating Temperature Range
-18ºC (0~F) to +57ºC (+135ºF)
Note: battery characteristics may limit this range
Dimensions
205 mmH x 160mmW x 39 mmD
Weight
960 g
Housing
Galvanized steel
Audio Output Level(ref.+/- 30kHz deviation
with 400Hz tone)
XLR connector (into 600 Q load): -30dBV
1/4 inch connector (into 3000 Q Ioad):-9dBV
Output Impedance
XLR connector: 200
1/4 inch connector: 1k
XLR output
Impedance balanced
Pin 1: Ground (cable shield)
Pin 2: Audio
Pin 3: No Audio
Sensitivity
-105 dBm for 12 dB SINAD, typical
Image Rejection
>70 dB, typical
Power Requirements
22V dc at 400mA, supplied by external
power supply
Specications
Appendix E