PICOBARISTO SM3061, HD8927 EN USER MANUAL 4219.460.3609.2 SM3061,HD8927 SAECO_PICOBARISTO OTC_WE_COVER_A5_FC.
1 2 3 4 ESPRESSO CAPPUCCINO ESPRESSO LUNGO LATTE MACCHIATO AROMA STRENGTH CAFFE CREMA 14 13 17 12 18 MENU / SPECIAL DRINKS 19 5 6 7 8 9 10 11 15 47 46 22 21 20 16 45 23 44 24 43 25 42 41 26 27 28 40 39 38 29 37 30 35 36 31 34 32 33
4 English Contents Machine overview_________________________________________________________________ Introduction ______________________________________________________________________ First installation___________________________________________________________________ AquaClean filter __________________________________________________________________ Activating the AquaClean filter_______________________________________________________ Replacing the AquaClean filter______________________________________
English 5 Machine overview 1 User interface 25 Drip tray release button 2 ESPRESSO button 26 Cord 3 ESPRESSO LUNGO button 27 Grind setting knob 4 CAFFÈ CREMA button 28 Cover of bean hopper 5 Escape button 29 Bean hopper 6 OK button 30 Brew group 7 Standby button 31 Inside of service door with cleaning instructions 8 Display 32 Coffee exit duct 9 MENU/SPECIAL DRINKS button 33 Coffee residues drawer 10 UP button 34 Coffee grounds container 11 DOWN button 35 Drip tr
6 English - This user manual for more detailed information on how to use the machine, how to keep it clean, how to descale it and how to solve problems. - This is the QR code. Scan this code to access instruction videos on how to brew the best coffees, how to clean the machine and for a list of frequently asked questions. (www.saeco.com/care) - The separate booklet with important safety information. First installation For first installation, follow the instructions on the separate quick start guide.
English 7 Note: Shake the AquaClean filter for about 5 seconds, immerse it upside down in a jug with cold water and wait until no more air bubbles come out. AQUACLEAN FILTER 0/8 ACTIVATE AQUACLEAN FILTER? 2 MIN INSERT FILTER FILL WATER TANK INSERT WATER SPOUT PLACE A CONTAINER UNDER THE WATER SPOUT 2 Press the MENU/SPECIAL DRINKS button, select MENU and press the OK button to confirm. Scroll to select AQUACLEAN FILTER. Press the OK button to confirm.
8 English - Then the machine ready screen appears with the AquaClean 100% icon to indicate that the filter has been activated. Replacing the AquaClean filter Note: Replace the AquaClean filter as soon as the capacity has dropped to 0% and the filter icon flashes quickly. Replace the AquaClean filter at least every 3 months, even if the machine has has not yet indicated that replacement is required.
English 9 measured water hardness is different, adjust the setting in the machine menu. 1 Immerse the water hardness test strip (supplied with the machine) in tap water for 1 second. 2 Remove the water hardness test strip and and wait for 1 minute. 3 Check how many squares have turned red and check the water hardness in the table below.
10 English MENU/SPECIAL DRINKS button Use the MENU/SPECIAL DRINKS button to prepare other drinks, like hot water and frothed milk. You can also use the MENU button to change the following settings: - Language: you can use the MENU button to set your preferred language. Display contrast Coffee temperature Stand-by time: this is the time after which the machine goes into standby mode. - Water hardness: to be able to adjust the machine settings to the water in your region, please measure the water hardness.
English 11 2 Pour one measuring scoop of pre-ground coffee into the pre-ground coffee compartment and close the lid. Caution: Do not put any other substance than pre-ground coffee in the pre-ground coffee compartment, as this may damage the machine. 3 Place a cup under the coffee dispensing spout. 4 Press the AROMA STRENGTH button and select the pre-ground coffee brewing function. 5 Press the OK button to confirm. The machine automatically starts brewing the selected beverage.
12 English 1 Place a cup under the open milk froth dispensing spout. 2 Choose your milk-based beverage. - Press the one-touch CAPPUCCINO or LATTE MACCHIATO button to brew one of these milk-based beverages right away. - Press the MENU/SPECIAL DRINKS button, choose DRINKS and scroll down through the drinks to select MILK FROTH. - The machine reminds you that you have to install the milk carafe and open the milk froth dispensing spout.
English Beverage name Description How to select Milk froth Hot milk with foam MENU/SPECIAL DRINKS Hot water 13 MENU/SPECIAL DRINKS Beverage lengths Beverage name Standard length Length range Espresso 40 ml 20 - 230 ml Ristretto 30 ml 20 - 230 ml Espresso Lungo 80 ml 20 - 230 ml Caffè Crema 125 ml 20 - 230 ml Espresso Double 60 ml (double grinding) 40 - 230 ml Hot water 300 ml 50 - 450 ml Adjusting volume and taste Adjusting coffee and milk volume You can adjust the volume of th
English 14 Adjusting coffee strength To change the coffee strength, press the AROMA STRENGTH button. Each time you press the AROMA STRENGTH button, the aroma strength changes by one degree. The display shows the chosen strength, which is only saved if you brew a coffee. 1 Very mild 2 Mild 3 Regular 4 Strong 5 Very strong 1 2 3 4 Note: The machine automatically dispenses the correct coffee volume for each coffee strength.
English 15 Cleaning and maintenance Note: Consult the table below for when and how to clean all detachable parts of the machine. For more detailed information on how to clean the brew group and how to descale the machine, read the corresponding chapters below or go to the dedicated website www.saeco.com/care. Cleaning table Part description When to clean How to clean Brew group Weekly Remove the brew group and clean it under the tap (see 'Cleaning the brew group under the tap').
English 16 Part description When to clean How to clean Pre-ground coffee compartment/coffee exit duct Weekly Clean the top part with a spoon handle as shown below. Cleaning the brew group Note: Scan the QR code or go to www.saeco.com/care for detailed instructions on how to disassemble and clean the brew group. Caution: Do not clean the brew group in the dishwasher and do not use washing-up liquid or a cleaning agent to clean it.
English 17 3 Put a coffee oil remover tablet in the pre-ground coffee compartment. 4 Press the CAFFÈ CREMA button. The machine dispenses water from the coffee dispensing spout. 5 When the progress bar has reached the middle, set the main switch on the back of the machine to OFF. 6 Let the degreasing solution work for approximately 15 minutes. 7 Set the main switch to ON. Press the standby button. 8 Wait until the machine performs an automatic rinsing cycle.
18 English - The hook is not positioned correctly if it is still in bottommost position. 3 Slide the brew group back into the machine along the guiding rails on the sides until it locks into position with a click. Caution: Do not press the PUSH button. 4 Close the service door. Lubrication For optimal performance of the machine, you have to lubricate the brew group. See table below for the lubrication frequency. For support visit our website: www.saeco.com/care.
English 19 3 Place the container under the milk froth dispensing spout. 4 Press the OK button to start dispensing hot water. Thorough cleaning of the milk carafe To clean the milk carafe thoroughly, you have to do the following regularly: 1 Remove the lid of the milk dispensing unit. 2 Lift the milk dispensing spout out of the milk dispensing unit. 3 Remove the milk tube from the milk dispensing spout. 4 Rinse the milk tube and milk dispensing spout with lukewarm water thoroughly.
20 English 2 Turn the milk dispensing unit upside down and hold it firmly in your hand. Pull the milk tube off the rubber support. 3 Press the release buttons on the milk frother and remove the milk frother from the the rubber support. 1 2 4 Pull the milk frother connector out of the milk frother. 5 Rinse all components under a lukewarm tap.
English 1 2 MAX MIN 3 4 5 6 7 8 9 10 21 Pour the contents of the milk circuit cleaner sachet in the milk carafe. Then fill the milk carafe with water up to the MAX level indication. Insert the milk carafe into the machine and place a container under the milk dispensing spout. Press the MENU button, select DRINKS and scroll to MILK FROTH. Press the OK button to start dispensing the cleaning solution. Repeat step 3 until the milk carafe is empty.
22 English 3 When the display asks 'Start descaling?', press the OK button to start the descaling procedure. 4 The display reminds you that you have to remove the AquaClean filter. Remove the filter and press the OK button. START DESCALING? 23 MIN Note: You can press the escape button to skip descaling. If you want to start the descaling procedure later, press the MENU button, select MENU and scroll to select DESCALING. Press OK to confirm. 5 The display reminds you that you have to empty the drip tray.
English 23 What to do if the descaling procedure is interrupted Once the descaling procedure has started, you must let the machine perform the entire procedure until the very end without switching off the machine. If the machine gets stuck during descaling, you can exit the descaling procedure by pressing the standby button. If this occurs, or in case of a power failure or accidental disconnection of the cord, do the following: 1 Empty and rinse the water tank thoroughly.
24 English Meaning of the error codes Below you find a list of the error codes that may appear on the display, their meaning and how to solve the problem. If these solutions do not help to remove the error code from the display and bring the machine back to normal working order, contact the Saeco hotline. Contact details can be found in the warranty booklet or on www.saeco.com/care.
English 25 Problem Cause Solution Make sure the main switch is set to 'on' position (I). The machine is in DEMO mode. You pressed the standby button for more than 8 seconds. Switch the machine off and then on again with the main switch on the back of the machine. The drip tray fills up quickly. This is normal. The machine Empty the drip tray when the 'drip tray uses water to rinse the internal full' indicator pops up through the drip circuit and brew group. Some tray cover.
26 English Problem The coffee has too little crema or is watery. Coffee is leaking from the coffee dispensing spout. Cause Solution The machine is still in the descaling procedure. You cannot remove the brew group when the descaling procedure is active. First complete the descaling process and then remove the brew group. The grinder is set to a too coarse setting. Adjust the grinder to a finer setting. The coffee blend is not the correct one. Change the coffee blend.
English 27 Problem Cause Solution The frothed milk is too cold. The cups are cold. Preheat the cups with hot water. The milk does not froth. The milk carafe is dirty or not inserted correctly. Clean the carafe and make sure that you position and insert it correctly. The milk dispensing spout has not been opened fully. Make sure that the milk dispensing spout is in the correct position. The milk carafe is incompletely Make sure that all the components assembled.
28 English Problem Cause Solution The AquaClean filter icon does not appear on the display after I replaced the filter. You did not confirm activation in the machine menu. Confirm the activation of the filter in the machine menu. If the display shows 'START CALC CLEAN', you first need to descale the machine. Remove the AquaClean filter before descaling and reinsert it afterwards. The AquaClean filter is installed, but the descaling message appears.
Milk circuit cleaner START DESCALING? 23 MIN
4219.460.3609.2 (11/2016) >75% recycled paper >75% papier recyclé www.saeco.