Specifications

Chapter 13: Digital Operator Monitor Display
Firmware – S2011 and S3012
Revision: 1 (9/98) 93 © Saftronics, Inc.
Table 28 Digital Operator Monitor Display (Continued)
LED Name Description
No. Contents
U−09
Maximum 4 faults can be monitored.
U−10
Lower 4 digits of PROM number can be monitored.
Elapsed time can be monitored as follows.
U−11
U−12
X X X X X X Elapsed time (in units of 1 hour)
U-10 (lower 4 digits)
U-11 (upper 2 digits)
Maximum 279,620 hours
Montr Monitor
U−13
PID feedback can be monitored. Display unit depends on the setting of n024.
Accel Acceleration time 1
Acceleration time 1 (n019) can be set/read in units of 0.1 seconds (1 seconds for 1000 sec and
above).
Decel Deceleration time 1
Deceleration time 1 (n020) can be set/read in units of 0.1 seconds (1 seconds for 1000 sec and
above).
Vmtr Motor rated voltage Motor rated voltage (n011) can be set during stop.
V/f V/f pattern selection V/f pattern selection (n010) can be set during stop.
Fgain
Frequency reference
gain
Frequency reference gain (n046) can be set during stop.
Fbias
Frequency reference
bias
Frequency reference bias (n047) can be set during stop.
FLA Motor rated current Motor rated current (n032) can be set during stop.
PID PID selection PID selection (n084) can be set during stop.
kWsav
Energy Saving
selection
Energy Saving selection (n095) can be set during stop.
PRGM PRGM mode Constants can be set/read.
efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor