Specifications

INDEX
Firmware – S2011 and S3012
Revision: 1 (9/98) 97 © Saftronics, Inc.
ON-delay timer, 87
open chassis type, 3, 70
open phase, 69
operating at low speed, 39
operating coasting motor without trip, 45
operating method for frequency reference loss
detection, 54, 86
operation mode selection, 60, 84
output characteristics, 70
output current, 92
output frequency, 10, 92
output frequency resolution, 70
output lag filter time, 88
output open-phase, 67
output phase loss detection delay time, 88
output phase loss detection level, 88
output terminal, 12
output voltage, 92
OV during stop, 68
overcurrent, 66
overload, 70
overload capacity, 70
overload relay trip contact, 80
overtorque detection, 66, 68
overtorque detection function selection, 43, 87
overtorque detection level, 43, 87
overtorque detection time, 43, 87
overvoltage, 66, 70
P
password, 84
periodic inspection, 64
phase advancing capacitor, 12
photo-coupler insulation, 21
PID selection, 88, 93
power charge indication, 70
power loss ridethrough time, 86
power rotation, 84
power supply, 70
preset V/f pattern, 37
PRGM mode, 93
primary delay time constant 89
proportional gain, 88
protective function, 70
Q
quick-start LED, 32
R
rated input voltage and frequency, 70
rated output current, 70
rated output frequency, 70
reducing motor noise or leakage current, 47
REMOTE, 25
reverse run, 10
reverse run prohibit, 38, 84
S
s-curve selection, 87
selecting stopping method, 48
sequence common, 10
sequence control input common, 21
sequence input signal, 21
sequence output signal, 21
serial communication/control circuit terminal selection, 51
shield sheath connection terminal, 10
shielded wire, 11
signal during running, 10
simultaneous forward/reverse run commands, 68
sine wave PWM, 70
slip compensation gain, 89
soft-start characteristics, 42
specification, 70
speed search command, 45
speed search level, 86
stall prevention, 70
stall prevention during deceleration, 87
stall prevention level during acceleration, 87
stall prevention level during running, 87
standard motor, 57
step voltage of tuning, 60, 88
stop key function, 84
stopping method selection, 84, 85
storage temperature, 70
surge suppressor, 12
switching frequency, 12
T
terminal function at 2-wire sequence selection, 51
terminal function at 3-wire sequence selection, 51
terminal screw, 17, 18, 19
test run, 26, 27
thermal overload relay, 12
thermistor, 70
time of average kW, 88
timer function, 52
torque compensation gain, 56, 87
torque detection, 43
twisted shielded wire, 17, 19
twisted-pair shielded wire, 11, 22
U
undevoltage, 70
undervoltage detection, 68
UP/DOWN command, 52
using analog input signals, 53
using frequency meter or ammeter, 46
using output signals, 55
using sequence input signals, 50
using two accel/decel times, 41
efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor