Specifications

Chapter 5: Simple Data Setting
Firmware – S2011 and S3012
Revision: 1 (9/98) 32 © Saftronics, Inc.
5.1 Digital Operator Key Description
Mode Indicator LED’s (Remote Mode)
Lights when selecting Input mode from the control circuit terminal or
serial communication.
SEQ: Lights when selecting RUN command from control circuit
terminal or serial communication.
REF: Lights when selecting frequency reference from control
circuit Terminals FV and FI or serial communication.
Display
Displays set values of each function or monitoring values such as
frequency and output current. (4 Digits)
Quick-Start LED’s
LED Description
Set/Read
During
Run
Fref Frequency reference setting/monitoring Enable
Fout Output frequency monitor Enable
Iout Output current monitor Enable
kWout Output power monitor Enable
F/R FWD/REV RUN command selection Enable
Montr Monitor selection Enable
Accel Acceleration time Enable
Decel Deceleration time Enable
Vmtr Motor rated voltage Disable
V/F V/f pattern selection Disable
Fgain Frequency reference gain Disable
Fbias Frequency reference bias Disable
FLA Motor rated current Disable
PID PID selection Disable
kWsav Energy Saving selection Disable
PRGM Constant number/data Disable
Enter Key
Displays each constant set value. By pressing this key again, the
set value is written in.
Number Change Keys
Changes set values or constant numbers.
∧ : Increment key
∨ : Decrement key
Operation Command Keys
Operation command keys operate the Inverter.
*STOP/RESET : Red LED lights by pressing STOP.
(Resets operation at faults. Reset is disabled
while a RUN command is ON.)
RUN : Red LED lights by pressing RUN.
Operation Mode Selection Key
The Operation mode is alternated between REMOTE and LOCAL
(Digital Operator).
Display Selection Key
Selects the contents of Quick-Start LED’s. (See Page 33)
Figure 17 Digital Operator Key Description
5.2 LED Description
By using the Quick-Start LED’s on the Digital Operator, simple operation of the Inverter is possible. Each Quick-Start LED is
selected each time DSPL key is pressed. Following is a table describing Quick-Start LED selection.
(Example of model FP5/GP5)
efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor