User`s manual

FP5/GP5User’s Manual 13
1.4 MOUNTING
PRECAUTIONS
1)When preparing to mount the FP5/GP5, lift it by its base. Never
lift it by the front cover.
2)Mount the inverter onto nonflammable material.
3)The FP5/GP5 generates heat. For the most effective cooling
possible, mount it vertically. For more details, refer to “Dimensions/
Heat Loss” on pages 15 & 16 and “Clearances” on page 17.
4)When mounting units in an enclosure, install a fan or other cooling
device to keep the intake air temperature below 113°F (45°C).
Failure to observe these precautions may result in equipment damage.
Choosing a Location
Be sure that the inverter is mounted in a location protected against the fol-
lowing conditions:
·Extreme cold and heat. Use only within the ambient temperature range:
14 to 104°F (-10 to 40°C).
·Direct sunlight (not for use outdoors)
·Rain, moisture
·High humidity
·Oil sprays, splashes
·Salt spray
·Dust or metallic particles in the air
·Corrosive gases (e.g. sulfurized gas) or liquids
·Radioactive substances
·Combustibles (e.g. thinner, solvents, etc.)
·Physical shock, vibration
·Magnetic noise (e.g. welding machines, power devices, etc.)
!
CAUTION
Chapter 1 - Receiving & Installation
Mounting
efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor