User`s manual

30 FP5/GP5 User’s Manual
PRECAUTIONS
1)Only turn ON the input power supply after replacing the front cover.
Do not remove the cover while the inverter is powered up.
2)When the retry function (n060) is selected, do not approach the
inverter or the load, since it may restart suddenly after being stopped.
3)Since the Stop key can be disabled by a function setting, install a sepa-
rate emergency stop switch to disconnect power or fault the inverter.
4)Do not touch the heatsink or braking resistor, due to very high tem-
peratures.
5)Since it is very easy to change operation speed from low to high
speed, verify the safe working range of the motor and machine before
operation.
6)Install a separate holding brake, if necessary.
7)Do not check signals during operation.
8)All inverter parameters have been preset at the factory. Do not change
the settings without thorough review of the possible consequences.
Failure to observe these precautions may result in equipment damage,
serious personal injury, or death.
!
WARNING
Chapter 2 - Operation
Precautions
efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor