User`s manual

FP5/GP5 User’s Manual 79

Chapter 3 - Programming Features

Inputs & Outputs

·Local/Remote Selection (setting: “LOCAL/REMOTE Sel”)

Selects whether the run command is received from the digital operator

or the control circuit terminal. Local/Remote selection is available only

while the inverter is stopped.

Open: Run according to the setting of operation mode selection (n002).

Closed: Frequency reference and run command from the digital oper-

ator.

Example: Set n002 to “SEQ=TRM REF=TRM”.

Open: Frequency reference from control circuit terminals FV & FI,

and run command from control circuit terminals S1 and S2.

Closed: Frequency reference and run command from the digital oper-

ator.

·Serial Communication/Control Circuit Terminal Selection (setting:

“COM/INV Sel”)

Selects operation reference by serial communication or by the control

circuit terminal. This selection is available only during stop.

Open: run according to the setting of operation mode selection (n002).

Closed: Frequency reference and run command from serial communi-

cation.

FWD Run/Stop

REV Run/Stop

Figure 47a Terminal Function at 2-Wire Sequence Selection (setting: n036=”Reverse RUN (2W)”)

Figure 47b Terminal Function at 3-Wire Sequence Selection (setting: n036=”FWD/REV Cmd (3W)”)

Run Command

(Run when “Closed”)

Stop Command

(Stop when “Open”)

FWD/REV Run Selection

(FWD Run when “Open”

REV Run when “Closed”)

Stop

Start

efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor