User's Manual

1 - INSTALLATION AND COMMISSIONING
Installation and User Guide - N56717020101
Page A1-16
No reproduction or communication without the written consent of
SAGEM SA
1.3.4 - Connecting on ADR LAN1 card
ADR LAN1
ETH
10
/
100 HALF
/
FULL
ETH
1 : TX_ETH_TIP 5 : NC
2 : TX_ETH_RING 6 : RX_ETH_RING
3 : RX_ETH_TIP 7 : NC
4 : NC 8 : NC
STATUS
10/100
Yellow LED :
Ethernet interface bite rate
ON : 100 Mbit/s
HALF/FULL
Yellow LED :
Ethernet interface type
(Half or Full Duplex)
ON : Full duplex
Contact 8Contact 1
NC : Reserved
LED STATUS
Green Red
ON OFF Card in service
ON ON Card in alarm
OFF OFF Hardware default (fuse)
OFF ON Card out of service
Flashing Autotest default
Yellow LED
: link status
ON : correct link
Green LED
: traffic status
ON : on reception
Figure 1-5 – Connecting ADR LAN1 card input
"ETH" Interface :
Port Traffic Ethernet interface operating at 10 or 100 Mbit/s in half-duplex or full-
duplex mode according to the mode used by the interlocutor (dynamic
adaptation of the Ethernet port on each new log-in of the interlocutor),
Connector Ethernet 10 or 100 BaseT - RJ48 Type (Shielded RJ45).
Pin 8
Pin 1
Front view
Pin N° Signal name Comments
1 TX_ETH_TIP Ethernet output (hot point)
2 TX_ETH_RING Ethernet output (cold point)
3 RX_ETH_TIP Ethernet input (hot point)
4 NC Reserved
5 NC Reserved
6 RX_ETH_RING Ethernet input (cold point)
7 and 8 NC Reserved
NOTE: Two LEDs are linked to the "ETH" interface:
• LED, "Activity", green colour : Trafic status indicator,
• LED, "Link", yellow colour : Link status indicator.
Electrical characteristics compliant with the IEEE 802.3U