Installation guide

Annex E - Default configuration
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page E-2 Sagem Communication document. Reproduction and disclosure prohibited
This section indicates the values of the default parameters of your router when it
leaves the factory.
These default parameters can be modified by a particular preconfiguration of your
router.
E.1 Default username and password
The default access level is Administrator. Its associated "username" and "password" are:
Username
admin
Password
admin
E.2 Default configuration for the local network(LAN)
The following table gives the values of the principal LAN parameters of your router (ETH, USB):
LAN characteristics Value State
ETH IP address
192.168.1.1 Internet and HTTP configurator access or
to a TV decoder
USB IP address
Internet and HTTP configurator access
BROADCAST, ARP, MULTICAST Activated
Router The LAN traffic is routed to your ISP
NAT/PAT Activated
E.3 Default configuration for the remote network (WAN)
Designation Value
VPI 8
VCI 35
Linking protocol PPPoA
DNS relay
DHCP server
ADSL/ADSL2/ADSL2+ Multimode