Installation guide

2 - Description and connection of router
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page 2-4 Sagem Communication document. Reproduction and disclosure prohibited
2.1.2 "LEDs" view
The different LEDs of the figure below are described in the following table:
Marking Abbreviation Meaning
PWR
Alarm LED (bicolour LED Green/Red):
• lits green if power is present,
• lits red in the case of failure detected at the time of starting.
• goes out if there is no power
ADSL
Green ADSL LED:
• blinks slowly when the ADSL is not detected,
• blinks quickly when the ADSL line is being synchronised,
• stays lit when the ADSL line is detected.
LAN
Green local network (LAN) LED:
This LED indicates data traffic between the router and the different
USB and Ethernet (ETH) interfaces.
• This LED is off if no interface (Ethernet or USB) is detected.
• This LED blinks when traffic is detected on one of the interfaces.
• This LED is lit when an Ethernet or USB interface is detected and
if no traffic is detected.
Internet
Internet connection LED (bicolour LED Green/Red):
• remains lit when the "PPP" connection is established or when the
router is in "Bridge" mode,
• lits green when the "PPP" connection is established,
• lits red when the "PPP" connection is not established,
• blinks when traffic is detected on the WAN interface.