Installation guide

5 - Information / Configuration
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page 5-2 Sagem Communication document. Reproduction and disclosure prohibited
5.1 Accessing the welcome screen
To access this screen, you must have configured your computer's network function
Ethernet or USB interfaces using the installation CD-ROM provided with your router
(cf. chapter 3).
If you are using your computer's Ethernet card to configure your router, connect it to the
Ethernet port whose yellow socket is marked ETH.
Your router is then configured using a simple Web browser (e.g. Internet Explorer).
The router's DHCP server function is activated by default with an address range
defined as indicated in §.5.8.2.
To access the configurer, proceed as follows:
1
In the Start menu, select All Programs / SAGEM F@st 1201, then left click on
.
2
The following screen asks you to connect.
Enter admin by default in the "Username" field.
Enter admin by default in the "Password" field.
Then click on OK to confirm.
Note: The equipment's IP address (192.168.1.1) appears in the bar at the top of the
screen.