Installation guide

5 - Information / Configuration
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page 5-22 Sagem Communication document. Reproduction and disclosure prohibited
Field Action Default
Inactivity Timeout
(minutes) [1-4320]:
2
Enter a value expressed in minutes between
1 and 4320 (i.e. 72 hours).
0
PPP IP extension
Check the box to allocate your computer the
public address obtained from the DHCP
server of your Internet Service Provider
(ISP). Therefore, your router will act as a
bridge between the server and your
computer.
Box
Not checked
Use Static IP Address
Check the box to use the static IP address.
Box
Not checked
IP Address:
3
Enter the static IP address
0.0.0.0
Configure PPP MTU
Enter an MTU (Maximum Transfer Unit)
value between 38 and 1492 (see Note).
1492
Enable PPP Debug mode
Check the box to use the PPP Debug mode.
In the event of connection failure, this option
will enable you to trace a possible problem
in the SYSLOG file.
Box
Not checked
Note: The MTU specifies the maximum size of the data used for packets expressed as a
number of bytes.
• Click on the Next button to continue configuring the remote network (WAN) in PPPoA
mode.
2
This field only appears when the "Dial on demand (with idle timeout timer)" field is activated (box checked).
3
This field only appears when the "Use Static IP Address" field is activated (box checked).