Installation guide

5 - Information / Configuration
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Sagem Communication document. Reproduction and disclosure prohibited Page 5-39
Field Action Default
Standard Mode
Check the box if you wish the IGMP snooping
runs in normal mode (transparency with
IGMP frames).
Box checked
Blocking Mode
Check the box if you wish the IGMP snooping
runs in blocking mode (interception and
removal of IGMP frames).
Box
not checked
Disable DHCP
Check the box to not activate your router's
DHCP server.
Note: You must configure your computer
with the parameters appropriate to
your local network (IP address,
subnet mask and default gateway) as
well as enter the primary and
secondary DNS server addresses.
Box
not checked
Enable DHCP
Check the box to activate your router's DHCP
server.
Note: You must configure your computer as
DHCP client and DNS client (or
enter the primary and secondary
DNS server addresses).
Box checked
Start IP Address
Enter the first address attributed by your
router's DHCP server.
192.168.1.2
End IP Address
7
Enter the last address attributed by your
router's DHCP server.
192.168.1.254
Lease Time (hour)
7
Enter an unavailability time for each address
attributed expressed in hours.
24
Configure the second IP
Address and Subnet
Mask for LAN interface
Check the box to configure the IP parameters
(IP address, subnet mask) of a second
address for the local network (LAN).
Box not
checked
IP Address
8
Enter a second address for your local
network (LAN).
_
Subnet Mask
8
Enter a subnet mask for the second address
for your local network (LAN).
_
7
This field only appears when the "Enable DHCP" field is activated (box checked).
8
This field only appears when the "Configure the second IP Address and Subnet Mask for LAN interface" field is
activated (box checked).