User manual

39
RTI90-320 T2 HD UK
9. Troubleshooting
Using the recorder
Symptom Action
The remote control is not working.
• Point the remote control at the recorder.
• Check the battery life and check the batteries are inserted
properly.
The recorder display shows no
information (no time, no channel
number, etc.).
• Switch the recorder on by pressing the On/Off button.
• Check all the connections (see Connections, page 12).
The recorder displays - -: - - in
standby mode.
• Take the recorder out of standby mode by pressing the key.
• Check that the antenna signal is correctly detected (see Antenna
Signal Information, page 38).
The recorder displays a black
screen or an error message.
• Check that the antenna signal is correctly detected (see Antenna
Signal Information, page 38).
• Search for programmes (see Searching for channels, page 35).
The picture is frozen ./ unclear.
• Check all the connections, check the antenna and search for
programmes again (see Searching for channels, page 35).
The recorder cannot find any
channels.
• Check the antenna reception (see Antenna Signal Information,
page 38).
• Search for programmes (see Searching for channels, page 35).
• Contact your antenna installer/dealer for more information on your
antenna installation.
The TV set does not switch to the
recorder when it leaves standby
mode.
• Check that your TV set is correctly connected to your recorder
(see Connection to the TV set, page 13).
• Select the appropriate input on your TV set.
There is no sound in HOME
CINEMA mode on some channels.
• Check that the recorder is connected to a Home Theatre amplifier
with a digital link (see Connection to a home theatre system,
page 15).
Black and white video on TV/AUX
output (during VCR/DVD
recording).
• Check that the signal type chosen for TV/AUX SCART output is
compatible with your VCR (select PAL on VCR, see Picture
settings, page 36).
I cannot channel-surf between all
my channels during a double
recording.
• In the case of a double simultaneous recording, you can only
channel-surf between a restricted number of channels. You will be
able to channel-surf between all your channels again when at
least one of the recordings ends.
A black screen (no video) appears
at the end of a recording.
• Some channels stop their broadcast with a fixed image or no
video. When a recording ends on such programmes, the video
recording stops but the time counter continues until the end of the
scheduled recording time. Make sure that you set your manual
recordings with the correct end time.
For any other problem.
• Perform a default factory reset (see Resetting the recorder,
page 37).
LU 253311796A RTI90-320 T2 HD UK.book Page 39 Jeudi, 8. avril 2010 8:06 08