User Manual

Turning on the appliance

NOTE

When you press the Start/ Pause to pause during washing, the

dishwasher will mooing every minute unless you press the Start/Pause

button to start.

Change the program

A wash cycle can only be changed if it has been running for a short time otherwise,

the detergent may have already been released and the dishwasher may have

already drained the wash water. If this is the case, the dishwasher needs to be reset

and the detergent dispenser must be refilled. To reset the dishwasher, follow the

instructions below:

1. Press the Start/Pause button to pause the washing.

2. Press Program button for more than 3 seconds, the machine will be in stand by

state.

3. Press the Program button to select the desired program.

4. Press the Start/Pause button, after 10 seconds, the dishwasher will start.

3 sec

Starting a wash cycle...

Draw out the basket(see the section entitled "Loading the Dishwasher").

Pour in the detergent (see the section“Fill the detergent”).

Insert the plug into the socket. The power supply is 220-240VAC 50 HZ, the

specification of the socket is 10 A 250 VAC.

Press the power button to turn on the appliance.

Connect the inlet hose to the tap, make sure that the water supply is turned on

to full pressure, or add water to the tank manually.

Select a suitable program according to the “Wash cycle table”.

If a program is selected, the response light will be on. Then press the

Start/ Pause button, the dishwasher begins to start.