Operation Manual

General functions
Switching on and off
1 Press »ON/OFF« to switch on the device from standby mode.
– The »
ON
•
« LED glows.
2 Press »ON/OFF« to switch the device to standby mode.
– The »
ON
•
« LED goes out.
Selecting the input source
1 Select the input source with »CD MW FM FM STEREO« (right side of
the device).
Adjusting the volume
1 Adjust the volume with » VOLUME |« (right side of the device).
Listening with headphones
1 Connect the headphones to the » 0 « socket (ø 3.5 mm) (left side of the
device).
– This automatically switches off the loudspeakers.
Radio operation
For the best FM (VHF) reception, it is sufficient to direct the wire antenna.
The radio has a built-in rod antenna for MW reception. Turn the device aro-
und to direct the antenna.
Selecting the radio input source
1 Set the sliding switch »CD MW FM FM STEREO« (right side of the
device) to »MW«, »FM« or »FM STEREO«.
Tuning radio stations
1 Select the frequency band (FM or MW) with »CD MW FM FM
STEREO« (right side of the device).
2 Set the desired radio station with »
TUNING
« (right side of the device).
Stereo/mono reception
If the sliding switch »CD MW FM FM STEREO« (on the right side of the
device) is set to »FM STEREO«, the device can receive FM stereo stations. If
this is the case, the »
FM STEREO
•
« LED glows. However, if the signal
from the FM stereo station is weak, you can improve the sound quality by
switching to mono reception.
1 Use the sliding switch »CD MW FM FM STEREO« (right side of the
device) to switch from »FM STEREO« to »FM«, i.e. mono.
– The »
FM STEREO
•
« LED goes out.
2 Use the sliding switch »CD MW FM FM STEREO« (on the right side
of the device) to switch from »FM« to »FM STEREO«, i.e. stereo.
OPERATION
__________________________________________
02 CD Clock Discalo CCD 6300,GB 31.03.2003 12:52 Uhr Seite 28