Operation Manual

ENGLISH
Setting the clock
When the device is switched on for the first time, »0
:
=0« appears in the dis-
play to indicate that the time must be set. The same applies if the device has
been disconnected from the mains and no back-up battery is inserted.
1 Set the sliding switches for the alarm function»e1 OFF ON ADJ«
and »e2 OFF ON ADJ« to »OFF«.
2 Press »TIME SET« and hold it down.
– Display: the time flashes.
3 Press »SKIP
4
I « briefly to set the hours step-by-step or hold it down
to run through the minutes quickly.
4 Press »I
3
SKIP« briefly to set the minutes step-by-step or hold it
down to run through the minutes quickly.
Note:
When the minute display changes from »59« to »00«, this does not
affect the hour display.
5 Release »TIME SET« to conclude the setting.
– Display: the current time.
Setting the alarm times
With this device you can set two alarm times.
1 Set the sliding switch »e1 OFF ON ADJ« (left side of the device) to
»ADJ«.
– Display: the last alarm time set flashes.
2 Press »SKIP
4
I « (top of the device) briefly to set the hours
step-by-step or hold down to run through the hours continuously.
3 Press »I
3 SKIP
« (top of the device) briefly to set the minutes
step-by-step or hold down to run through the hours continuously.
4 To end the setting set the sliding switch »e1 OFF ON ADJ« (on the
left side of the device) to »ON«.
– Display: the LED »e1
•
« glows, i.e. the alarm setting with alarm
time 1 is activated.
5 To set alarm time 2, repeat steps 1 to 4 with the sliding switch
»e2 OFF ON ADJ« (left side of the device).
– Display: the LED »e2
•
« glows, i.e. the alarm setting with alarm
time 2 is set.
SETTINGS
______________________________________________
02 CD Clock Discalo CCD 6300,GB 31.03.2003 12:52 Uhr Seite 27