Instructions / Assembly

6
TM
Spreader Operation.
1. Due to the rate at which materials absorb moisture dif-
ferently, some materials may not perform as desired.
Therefore, the substitution of an alternative material may
be necessary for optimum performance.
2. When filling hopper use supplied screen to prevent large
chunks of material and debris contained in the material
to get into hopper and cause operational problem or
damage.
3. Material must never be left in the hopper for extended
period of time. Material will absorb moisture, bind, hard
-
en and may prevent spreader from proper operation or
may damage the spreader.
4. To start spreader make sure that truck engine is running.
Flip POWER switch in ON position. Switch will illuminate.
Spreader motor will accelerate to full speed and then it
will slow down to previously dialed speed.
5. To adjust material flow rate and spreading distance, sim
-
ply rotate speed knob to desired speed. Spreader can
be put in full speed mode for short time by pressing and
holding BLAST button.
6. To activate and deactivate vibrator press VIBRATOR
button.
7. In addition material flow rate can be controlled by adjust
-
ing inverted vee, located inside hopper. To reduce mate-
rial flow, lower inverted vee towards auger. For slow and
difficult to flow materials inverted vee can be raised or
completely removed.
8. In addition, material flow and pattern can be adjusted
by opening/ close adjustable discharge on the trough
bottom.
Controller Warnings.
Check controller instruction sheet for latest controller
updates, troubleshooting codes. Controller instruction sheet
is inside controller shipping box.
IMPORTANT! INSTALLER, DO NOT DISCARD
CONTROLLER INSTRUCTION SHEET. STAPLE SHEET
TO SPREADER MANUAL AND GIVE TO END USER!
Maintenance Instructions.
1. Wash spreader after every use. Make sure no material
left under auger and/or inside trough.
2. Inspect and retighten fasteners after every 5-7 hours of
operation.
3. Lubricate bearing every 7-10 hours of operation using
general automotive grease.
4. Inspect terminals/ connectors every time you disconnect
spreader from wire harness. Apply thin layer of dielectric
grease on terminals. If any tarnish/corrosion found, clean
terminals and apply dielectric grease.
End of Season Maintenance.
1. Wash spreader. Make sure no material or residue left in
and outside hopper.
2. Lubricate bearing using general automotive grease.
3. Inspect wire harness, connectors for broken insulation,
missing components. Replace if necessary.
4. Apply dielectric grease on all electrical connectors.
5. Store hopper indoors, in dry, cool place.
6. Inspect, clean and repaint frame.
7. Remove controller from truck. Store controller indoors, in
dry, cool place.