Replacement Part List

4
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone [phone] • Fax [phone]
Toll-Free Fax [phone] • buyersproducts.com
3017110 _ B
8. Connect the wire harness to the motor.
Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion.
DO NOT CONNECT WIRE HARNESS TO DAMAGED
OR CORRODED TERMINALS!
IT MAY RESULT IN OVERHEATING, LOST POWER
AND POTENTIAL CONTROLLER DAMAGE!
9. Connect the power cable directly to the battery.
10. Insure all functions of the controller are working
properly.
11. Observe spinner direction of rotation. The correct
direction is counter clock wise when looking inside
hopper from the top. If direction is clock wise reverse
wires between Motor and Wire Harness.
Spreader Maintenance
1. This spreader is designed to use loose free floating
materials such as #1 dry Rock Salt. Using different
grades and/or wet material will affect spreader per
-
formance. Wet material can “bridge" and stop floating
onto spinner disk.
2. Make sure lid is installed and latches are secured
when spreader is in use.
3. Do not leave material in hopper between uses.
4. Do not drive with material in hopper.
5. Always clean/ wash hopper at the end of the day.
6. Spray lubricant around motor shaft to prevent
water from penetrating into the motor.
7. Apply dielectric grease to all electrical connectors
between uses and for long term storage.
IMPORTANT
IMPORTANT Make sure all wires securely attached to
vehicle or spreader’s frame. Use wire ties and/or wire
clamps to attach wires. All excess wires must be rolled
into bungles and attached to vehicle or spreader.
CAUTION
Do not attempt to tilt spreader with material in it and/or
while vehicle is moving.
Fig. 5
3011864
3008620
3035934
CB50PB
3001379
BATTERY POSITIVE
BATTERY NEGATIVE