Operation Manual

6: EDIT Control – This rotary encoder control knob is used to control and set several
menu functions and parameters displayed in the LCD display and it is also used to
preform the automatic Channel Scan.
7: Power Switch - Use this to turn the AR300 power on and off. When the receiver is
on, the LCD backlight is lit.
8: IR Transmitter – During “IR SET” an Infrared light is used to set the transmitter
channel.
9: RF Meter – 12-segment bar meter used to display the level of the radio frequency
reception.
10: LCD Display – The 47mm x 17mm backlit display show information for Frequency,
Channel, Group, Absolute Channel, Antenna, AF, RF, Scan, and IR Set.
11: AF Meter - 12-segment bar meter used to display the amount of the audio input
level.
12: Level control - This knob sets the level of the audio signal being output through
both balanced output connectors on the rear panel (see C and D on page 12 in
this manual). Reference level is obtained when the knob is turned fully clockwise
(to its “10” setting).
Guided Tour - AR300 Receiver / Front Panel
11