PORTABLE PA SYSTEM Owner's Manual

Operating the EXPEDITION EXPRESS

BASIC OPERATION

The following section explains the basic operation of the EXPEDITION EXPRESS.

CONNECTING MICROPHONES AND INSTRUMENTS

1. Before connecting mics or instruments,

make sure that the power of all your

systems components including the

EXPEDITION EXPRESS is turned off. Also,

make sure that the MAIN VOLUME control

is turned all the way down.

2. Connect the cables to your microphones

and instruments, and insert the other end

of the cable firmly into the appropriate

input on the EXPEDITION EXPRESS.

3. Switch on the power of any periph-

eral devices, and then power up the

EXPEDITION EXPRESS.

NOTE: It is important to remember the

Golden Rule of audio … " LAST ON, FIRST

OFF". Translated, this means that when

turning on your system, you should always

turn your power amplifiers or powered

monitors on LAST, and when turning your

system off, turn your power amps off FIRST.

This helps avoid any loud pops caused

by inrush current at power up, which can

sometimes damage loudspeakers.

4. Set the MAIN VOLUME in the

EXPEDITION EXPRESS’ master section to

the "5" position.

5. While speaking into the mic (or playing

the instrument), adjust the channel VOLUME control to set the desired level.

Using The Docking Station

The EXL250 has a built-in MP3 docking station, which fits neatly into a special com-

partment above the EXL250’s mixer allowing you to install an MP3 player to provide

background music for meetings or performances. The EXL250’s docking station is com-

patible with most popular MP3 players that have a 30-pin connector on the bottom.

Follow the steps below to install your MP3 player.

• If your MP3 player came with a dock adapter, fit it in the EXL250’s docking station.

• Pull the spring loaded retaining bracket forward and slide your MP3 player into

place making sure it mates properly with the 30 pin connector.

• If you have a thin style MP3 player, remove your MP3 player and install the included

thick EVA foam.

• Then, pull the spring loaded retaining bracket forward to re-install the MP3 player.

• Slowly lower the spring loaded retaining bracket to hold the MP3 player in place.

MP3

ENGLISH