User Manual

Owners Manual4
Quick Start
Please follow these basic procedures for setting up and using your AirLine Micro:
1. For your AirLine Micro system to work correctly, both the receiver and transmitter must be set to the same channel. Remove
all packing materials (save them in case your unit needs service in the future) and check to make sure that the supplied
receiver and transmitter are set to the same channel.
Note: The channel number is laser-engraved on the back of the AR2 and AH2 chassis. If these channels do not match, please
contact Samson Technical Support at 1-800-372-6766. If your unit was purchased outside of the U.S., please contact your local
distributor.
2. Before using your AirLine Micro system you should fully recharge the transmitter and receiver batteries. Plug the AC adap-
tor into a power socket. Connect the USB Y-Cable into the USB socket on the AC adaptor. Plug the two mini-USB connectors
into the USB ports on the AH2 transmitter and AR2 receiver. When the transmitter and receiver are completely charged, the
BLUE LED indicator will turn off.
3. Remove the USB cable and continue with setup.
4. Physically place the receiver where it will be used (if desired, the AR2 receiver model can be used with the included AR2D
dock) and fully extend the antennas vertically.
5. Turn your audio system off and connect the receiver’s 1/8” unbalanced output jack to the microphone or line level audio
input of your amplifier or mixer. Set the AR2 Mic/Line Level switch to match the input.
6. Turn on the receiver using the Power Switch. When on, the Status Indicator will be steady YELLOW.