User manual

Chip Resistor
- 5 -
The Resistance Tolerance is expressed as 1 digit alphabet by EIAJ standard. <Table 2>
<Table 2>
Type Representation : G(General), P(Precision), L(Low ohms), T(Trimmable)
The Nominal Resistance Value is e xpressed as 3 or 4 digits by EIAJ standard. <Table 3>
<Table 3>
Item 3 Digits mark 4 Digits mark
Resistance
Tolerance
F, G, J, K, L, M
F, G
Only number
Left 2 digits : Resistance value
Right 1 digit : Exponential number of 10.
Left 3 digits : Resistance value
Right 1 digit : Exponential number of 10.
Number &
alphabet "R"
Read alphabet "R" as decimal point.
Read alphabet "R" as decimal point.
Example
1) 101 : 10
×
10
1
=10
×
10 = 100
Ω
2)7R5:7.5=7.5
Ω
3) R75 : 0.75
Ω
1) 1001 : 100
×
10
1
= 100
×
10 = 1
㏀
2) 9R09 : 9.09 = 9.09
Ω
If resistance value in E-96 is same resistance value in E-24, we mark 3 or 4 digits on the
resistor.
In case of JUMPER(0 ohm), '000' is marked on that resistor.
Item F G J K L M
Tolerance (%)
±
1
±
2
±
5
±
10
±
15
±
20
Producing Series E-24, E-96 E-48 E-24 E-12 E-9 E-6
Type P, L G, L G, L G, L, T T T
RESISTANCE TOLERANCE
●
3
●
4
NOMINAL RESISTANCE VALUE