User Manual

42 English
Maintenance
Maintenance
Burner reinstall guide
Dual burner head
1. Orient the burner head so that the
opening for the electrode lines up with
the electrode.
2. Install the burner head so that the
electrode passes through the opening for
the electrode. Make sure the burner head
lies at on the stove top.
Round burner head
1. Orient the burner head so that the
opening for the electrode lines up with
the electrode.
2. Install the burner head so that the
electrode passes through the opening for
the electrode. Make sure the burner head
lies at on the stove top.
Brass burner head
NOTE
• The brass parts of your burner will change
color with use. However, this will not
affect performance and you can clean the
brass parts with a brass cleaner.
• After cleaning, conrm that the burner
port openings aren't plugged.
• Shake out any excess water and then let
burner heads and caps dry thoroughly.
Placing the center burner upside down
will allow the water to drain out more
easily.
• Do not wash any burner components in a
dish washer.
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.
• The burner head can be blocked by food or dust. Clean the head if it appears
blocked. If you clean the head with water, assemble it only after it is completely
dry. If the head is wet, it might prevent the burners from igniting.
• To avoid falling down the grates, make sure to remove both sides grates rst.
• Do not attempt to remove center oval burner cap from the head.