Installation Manual

English 15
Installation requirements
Recommended locations for gas piping and electrical outlets
(For model NX60*8***** / NX60**8*******)
Recommended area for Recommended area for
120V electrical outlet 120V electrical outlet
on rear wallon rear wall
Recommended Recommended
positionposition
30 in (76.2 cm) 30 in (76.2 cm)
Cabinet OpeningCabinet Opening
17 in (43.2 cm)17 in (43.2 cm)
12 in 12 in
(30.5 cm)(30.5 cm)
Gas Wall AreaGas Wall Area
Recommended area for Recommended area for
through-the-wall and through-through-the-wall and through-
the-oor connection of gas the-oor connection of gas
pipe stub and shut-off valve.pipe stub and shut-off valve.
Gas Floor AreaGas Floor Area
17 in 17 in
(43.2 cm)(43.2 cm)
9 in 9 in
(22.9 cm)(22.9 cm)
2 in 2 in
(5.1 cm)(5.1 cm)
CAUTION
You must use the rear ller kit to install the range in a freestanding cutout cabinet.
For more information, see “Optional rear ller kit” as shown below.
Optional rear ller kit
WARNING
Used to ll gap between the range back and wall. Adds a ller strip to the rear of
the range. This kit can only be used when the opening in the countertop is 25” deep.
NOTE
If the countertop depth is greater than 25”, there will be a gap between the ller
kit and the back wall.
To avoid breakage
CAUTION
Please DO NOT push the unit strongly when
you install. These actions can cause the
damage to the unit.
Please DO NOT push the burner knobs when
installing the range.
(Grasp the L/R door area to push the unit.)