User manual

143
Settings
6
6 Settings
6.11.4 Standby Control
You can set the screen standby mode to be applied when an input signal is received.
Setting Standby Control
1 Press MENU on the remote control.
2 Press / to move to Setup and press [ ].
3 Press / to move to Advanced Settings and press [ ].
4 Press / to move to Standby Control and press [ ].
5 Press / to move to the option you want and press [ ].
z Auto
Power-saving mode will activate if no input signals are detected even though a source device is
connected to the display.
The message "No Signal" will appear if no source device is connected.
z On
Power-saving mode will activate if no input signals are detected.
z Off
The message "No Signal" will appear if no input signals are detected.
6 The selected option will be applied.
z The Standby Control option is only enabled when Source is set to PC or DVI.
z If "No Signal" is displayed although a source device is connected, check the cable connection.
Refer to page 56 for details about connecting source devices.
S t a n d b y C o n t r o l
M o v e E n t e r
R e t u r n
A u t o
O f f
O n