Instruction manual

Page 32 of 100 Report No. 255837
TRF No. IEC60335_2_40F
IEC 60335-2-40
Clause Requirement – Test Result Verdict
22.7
Adequate safeguards against the risk of excessive
pressure in appliances provided with
steam-producing devices
No steam-producing devices. N/A
22.8
Electrical connections not subject to pulling during
cleaning of compartments to which access can be
gained without the aid of a tool, and that are likely to
be cleaned in normal use
P
22.9
Insulation, internal wiring, windings, commutators
and slip rings not exposed to oil, grease or similar
substances
Not exposed to oil, grease or
similar substances.
P
Adequate insulating properties of oil or grease to
which insulation is exposed
N/A
22.10
Not possible to reset voltage-maintained
non-self-resetting thermal cut-outs by the operation
of an automatic switching device incorporated within
the appliance (IEC 60335-1/A1)
No such components. N/A
Non-self resetting thermal motor protectors have a
trip-free action, unless (IEC 60335-1/A1)
Self resetting thermal motor
protectors.
N/A
they are voltage maintained (IEC 60335-1/A1)
N/A
Location or protection of reset buttons of
non-self-resetting controls is so that accidental
resetting is unlikely (IEC 60335-1/A1)
No reset button. N/A
22.11
Reliable fixing of non-detachable parts that provide
the necessary degree of protection against electric
shock, moisture or contact with moving parts
Fixed in a reliable manner by
metal screws, and adequate to
withstand the mechanical
stress.
P
Obvious locked position of snap-in devices used for
fixing such parts
P
No deterioration of the fixing properties of snap-in
devices used in parts that are likely to be removed
during installation or servicing
P
Tests as described
50 N. P
22.12 Handles, knobs etc. fixed in a reliable manner
No such parts. N/A
Fixing in wrong position of handles, knobs etc.
indicating position of switches or similar components
not possible
N/A
Axial force 15 N applied to parts, the shape being so
that an axial pull is unlikely to be applied
N/A
Axial force 30 N applied to parts, the shape being so
that an axial pull is likely to be applied
N/A
22.13
Unlikely that handles, when gripped as in normal
use, make the operators hand touch parts having a
temperature rise exceeding the value specified for
handles which are held for short periods only
No such parts. N/A